WAGNER FORCE TEN Dokumentacja Pobierz pdf (Strona 11)

NOTE: Although any weight or force up to 100% of the load cell

capacity can be tared , the net capacity of the gage will decrease if

the tare is more than 25% of the load cell nominal capacity:

NET CAPACITY = 125% NOMINAL CAPACITY MINUS(-) TARE

4. The LCD will display a “C” if the currently applied force is a compres-

sion force and a “T” if the currently applied force is a tension force.

5. Peak Hold - Displaying Peak Readings

The FDV continuously tracks the highest peak compression and

highest peak tension readings. While tracking, the FDV also retains

the peak values, allowing both peaks to be captured during a single

test. Pressing the PEAK button activates the peak mode prior to

commencing the test.

Pressing the PEAK button repeatedly, after concluding a test, dis-

plays in succession:

- Peak compression reading

- Peak tension reading

- Current applied force

If the currently displayed reading is a peak reading, then the "PEAK"

indicator will be displayed. In addition, a peak compression reading

will have the "C" indicator and a peak tension reading will have the

"T" indicator displayed.

To clear the peak readings and zero the FDV for the next test, press

the ZERO button. The FDV remains in the peak mode after the gage

is zeroed. To exit the peak mode press the PEAK button, and to

confirm, note that the "PEAK" indicator is no longer displayed.

CAUTION: EXCESSIVE OVERLOADS over 25% above maximum

capacity or IMPACT LOADING may cause permanent damage to load

cell. EXERCISE CAUTION to prevent overloading or impact loading.

RECOMMENDATION: Precise axial loading of 5 lb and 10 lb FDV

force gages is recommended. When using the FDV 5 and FDV 10

Force Cell Modules take extra care to apply loads axially to the load

shaft. This will avoid side loading of the Force Cell Module and

prevent significant errors.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Brak uwag

WAGNER FORCE TEN Dokumentacja Strona 11